Table of Contents
Advertisement
7.
Remove the screws (5 mm and 6 mm) from
the muffler protector, and remove the muffler
protector
(Figure
8.
Remove the screws (4 mm) from the spark
arrester, and remove the spark arrester from the
muffler
(Figure
49).
9.
Use a brush to carefully remove carbon deposits
from the spark-arrester screen
Note:
Replace the spark arrester if it has
breaks or holes.
Figure 50
1. Screen
10.
Install the spark arrester, muffler protector,
exhaust deflector, and muffler in the reverse
order of disassembly.
11.
Install the divider plate (if equipped); refer to
Installing the Divider Plate (page
49).
(Figure
50).
2. Brush
29).
Drive System
Maintenance
Tire Air Pressure
The following table shows the appropriate air pressure
for the tires as installed at the factory.
Important:
Always check the information on
the actual tires for the correct air pressure
requirement.
Model
68004
68006, 68007, 68008, 68009,
and 68011
Inspecting the Tires
g208746
Service Interval: Before each use or daily
WARNING
Failure to maintain correct tire pressure
may result in tire failure and loss of control,
resulting in property damage and serious
injury or death.
• Check the tire pressure frequently to
ensure proper inflation. If the tires are not
inflated to the correct pressure, they will
wear prematurely.
• Inspect the tire condition before towing
and after any operating accident.
The DOT tire information is located on the side of
each tire. This information gives load and speed
ratings. Replacement tires should have the same or
better ratings
Note:
Ensure that any tires installed on your machine
meet or exceed the weight requirements of your
machine as listed in
1.
Visually inspect the tires for damage and wear
(Figure 51
35
Maximum Air Pressure
414 kPa (60 psi)
241 kPa (35 psi)
Specifications (page
and
Figure
52).
15).
Advertisement
Table of Contents
