ABB PST Series Installation And Commissioning Manual page 16

&KDSWHU 
4XLFNVWDUW
#RRNKECVKQP 5GVVKPI
5GNGEV
)LJXUH  $SSOLFDWLRQ VHWWLQJ PHQX
%GPVTKHWICN 2WOR
5VQTG 5GV $CEM
)LJXUH  &HQWULIXJDO SXPS
%GPVTKHWICN 2WOR
0GZV
)LJXUH  &HQWULIXJDO SXPS VWRUHG
5GVVKPI +G #
5VQTG
)LJXUH  6HWWLQJ ,H
5GVVKPI +G #
0GZV $CEM
)LJXUH  6HWWLQJ ,H VWRUHG
1. %NCUU
5VQTG
)LJXUH 2/ &ODVV
1. %NCUU
0GZV
)LJXUH  2/ FODVV VWRUHG
'ZV $[2CUU
5VQTG
)LJXUH  ([WHUQDO %\SDVV
'ZV $[2CUU
0GZV
)LJXUH  ([WHUQDO %\SDVV VWRUHG
4GCF[!
;GU 6WPG 5GV
)LJXUH  5HDG\  7XQH 6HW
16
Configuration
 
$CEM
$CEM


$CEM
0Q
0Q
$CEM
 
&RQILJXUDWLRQ
1 Enter the Application Setting by pressing left selection
key twice. Press 6HOHFW using the left selection key.
2. Select the appropriate type of load using navigation
keys.
3. Press 6WRUH 6HW and 1H[t to continue or %DFN to previ-
ous parameter using the selection keys.
4. Set the Setting Ie using the navigation keys.
In Line connected = rated motor current
Inside Delta connected = 58% (
motor current.
5. Press 6WRUH and 1H[W to continue or %DFN to previous
parameter using the selection keys.
6. Set the required overload class using the navigation
keys.
7. Press 6WRUH and 1H[W to continue or %DFN to previous
parameter using the selection keys.
8. If an external by-pass contactor is used set ([W %\3DVV
to <HV using the navigation keys. (PST30...300 only).
9. Press 6WRUH and 1H[W to continue or %DFN to return to
previous parameter using the selection keys.
10.Select <HV if ready or 7XQH 6HW if ramp times, initial
voltage, current limit etc. needs to be adjusted using
selection keys.
6WDUW RI WKH PRWRU
1 Switch on the main voltage.
2. Give start command to the softstarter.
(To start the softstarter from the keypad, enter the
LOCAL CONTROL menu, select 6WDUW6WRS and press
6WDUW. The motor must be stopped before leaving this
menu.)
e
) of the rated
1 3
1SFC132003M0201