ABB PST Series Installation And Commissioning Manual page 127

1SFC132003M0201
  2YHUORDG FODVV GXDO W\SH UXQ
FODVV
3DWK LQ PHQX
0HQX6(77,1*6)XQFWLRQDO 6HWWLQJV
3URWHFWLRQV2YHUORDG'XDO &ODVV 5
This parameter makes it possible to set the required class
of the overload protection for continuous run. The run
class is activated 30 seconds after full voltage has been
reached.
3DUDPHWHU 'HIDXOW YDOXH 6HWWLQJ UDQJH
WH[W
OL Class R 10
  2YHUORDG SURWHFWLRQ W\SH RI
RSHUDWLRQ
3DWK LQ PHQX
0HQX6(77,1*6)XQFWLRQDO 6HWWLQJV
3URWHFWLRQV2YHUORDG2/ 2S
This parameter makes it possible to select between three
different actions by the softstarter when the protection is
activated. It is active only if the motor overload protection
is selected.
Stop–M
Stop–A
Ind
3DUDPHWHU 'HIDXOW YDOXH 6HWWLQJ UDQJH
WH[W
OL Op Stop–M
10A, 10, 20, 30
The motor stops and a manual reset is
required before restart.
The motor stops and an automatic reset is
performed when the fault disappears
The motor continues to run but a fault indi-
cation is given.
Stop–M, Stop–A,
Ind
&KDSWHU 
)XQFWLRQV
'HVFULSWLRQ
Overload class,
Dual type, Run
Class
'HVFULSWLRQ
Type of opera-
tion for over-
load protection
127