ABB PST Series Installation And Commissioning Manual page 102

&KDSWHU 
)LHOGEXV FRPPXQLFDWLRQ RSWLRQ
102
  'HYLFH1HW
The DeviceNet protocol is a fieldbus protocol that provides
full control and status information on the softstarter as well
as reading and writing of parameters. Through the fieldbus
it is possible to start and stop the motor, perform jog,
sequence start, read out currents and frequency, acquire
information about protections, warnings, faults and much
more.
See chapter 7 "Settings and configuration" for
programming the inputs / outputs.
Before the DeviceNet fieldbus can be put into operation,
the following parameters must be set in the softstarter:
• Parameter )LHOGEXV &WUO set to Yes
• Parameter )LHOGEXV 7\SH set to other
• Parameter )LHOGEXV $GGU set to a free communication
address.
:DUQLQJ
,I WKH PRWRU LV UXQQLQJ DQG WKH SDUDPHWHU )LHOGE &WUO LV
FKDQJHG IURP 1R WR <HV WKLV ZLOO VWRS WKH PRWRU ILHOGEXV
FRQWURO RYHUULGHV WKH SURJUDPPDEOH LQSXWV 
,I WKH PRWRU LV QRW UXQQLQJ DQG WKH SDUDPHWHU )LHOGE
&WUO LV FKDQJHG IURP <HV WR 1R WKLV PLJKW VWDUW WKH PRWRU
LI WKHUH LV D VWDUW VLJQDO SUHVHQW RQ WKH SURJUDPPDEOH
LQSXWV
For installation and commissioning of the DeviceNet
fieldbus, see document 2CDC193002D0201 available at
www.abb.com/lowvoltage.
)RU WKH VHWXS RI WKH 3/& VSHFLILF VRIWZDUH LV UHTXLUHG
ZKLFK LV DYDLODEOH RQ WKH 6RIWVWDUWHU SDJHV
/RRN XQGHU WKH GRFXPHQWDWLRQOLQN QDPHG 6RIWZDUH
,I \RX QHHG KHOS RU DGYLFH SOHDVH FRQWDFW \RXU ORFDO $%%
RIILFH
1SFC132003M0201