Table of Contents
Advertisement
SYSTEM MENU – SCREENS MANAGEMENT – COPY SCREENS SETTINGS
This menu allows to copy screen's data, (TOP/BOTTOM LED BAR, TONE GENERATOR, ALARM's table of the
SCREEN SETTINGS) from the current screen to the another screen of the same or the other sensor.
Screen template specific data (in SCREEN SETTINGS menu) are not copied if destination screen template type
is different to current copy source. Rest is copied.
CONTROLS:
1.
DATA
Sets data going to be copied.
ALL
TOP LED BAR
BOTTOM LED BAR
TONE GENERATOR – copies TONE GENERATOR settings.
ALARMS
2.
DESTINATION
Sets destination screen where selected data will be copied. If ALL is selected, data will be copied to all
screens of selected sensor EXCEPT disabled screens (NO in SENSOR x SCREENS ORDER menu).
3.
SENSOR
Sets destination sensor where selected data will be copied.
COPY
4.
Select and push EDIT button to confirm copy.
SYSTEM MENU – SCREENS MANAGEMENT – COPY COMPLETE SCREEN
This menu is similar to the previous menu but allows to copy screens at a higher level. Again it allows to select
data (CURRENT SCREEN), destination and sensor for copying but logically serves to copy complete screen
including customized screen layout (selected units, point of measurement, power and impedance types) in place
of another screen for the same or different sensor.
At the same time, this menu can be used to create a new screen from scratch by selecting one of the default
template type to replace another screen. Essential feature if you inadvertently overwrite some screen and you
haven't any other template of the same type available.
microHAM © 2015 All rights reserved
1
2
3
– copies TOP LED BAR settings, BOTTOM LED BAR settings,
TONE GENERATOR settings, and ALARM table at once.
– copies TOP LED BAR settings.
– copies BOTTOM LED BAR settings.
– copies ALARM table.
48
4
Advertisement
Table of Contents
