Table of Contents
Advertisement
This menu serves for setting of everything related
to the LAN connectivity and shows real time status
of the network connection.
CONTROLS:
LAN ENABLED
1.
Enables or disables LAN connection.
YES enables LAN connectivity.
Please note, ANY change of ANY
parameter in this menu automatically
disables LAN connection and must be
manually re-enabled.
STATUS
2.
Shows status of the current connection.
Normally you should see just DISABLED
and RUNNING state, but there are more
states describing status which may help for
network troubleshooting:
DISABLED
DOWN
CONNECTING
WAIT SWITCH
DHCP SEEK
RUNNING
DHCP
3.
Lets assignment of the connection parameters to the DHCP server of your internet connection, usually
your local Router or ISP.
MANUAL
4.
Allows to set the IP ADDRESS, NET MASK, GATEWAY and DNS ADDRESS manually. When you
consequently re-enable LAN, parameters are copied to appropriate positions at DHCP fields.
LOCAL NAME
5.
Sets name of the SMΩRF for local network.
6.
RESET PASSWORD
Allows to reset password for HTTP and DATA port.
Default access is:
login: admin
password: admin
HTTP PORT
7.
Sets HTTP port, default port number is 80.
Next to port number, real time status is shown: CLOSED, when there is no connection; SERVING, when
browser is connected and user is logged in. HTTP port is protected by password.
Please note, if you have changed HTTP port, you have to leave the menu and restart SMΩRF (turn it off
and back on). New port address is applied after restart.
DATA PORT
8.
Sets DATA port, default port number is 1234. This port is used by native Remote Control application.
When SMΩRF is under external DATA control, local operation is disabled and "REMOTE" is shown on
display. Data port is protected by password.
9.
VNC ENABLED
Enables or disables internal VNC server. VNC server can be also enabled or disabled through the web
interface.
microHAM © 2015 All rights reserved
SYSTEM MENU – LAN SETTINGS
– LAN connection is turned off
– internal PHY is turned off
– waiting for cable connection
– waiting for response from the LAN switch
– waiting for response from the DHCP server
– LAN connection is running
42
Advertisement
Table of Contents
