Table of Contents
Advertisement
VNC PORT
10.
Sets VNC port, default port number is 5900. Next to port number, real time status is shown: CLOSED,
when there is no connection, IP address of the client when connected.
11.
MAC ADDRESS
Shows SMΩRF's unique network MAC address, necessary for remote wake-up from Remote Control
application.
This menu allows to set power saving and wake up parameters for OLED display as well as for complete
SMΩRF.
CONTROLS:
SCREEN SAVER
1.
Sets time of inactivity in minutes, after which display enters the Screen Saver Mode. SMΩRF exits screen
saver automatically when detects power data from the sensor or when any button is pressed. Screen
saver can be set to blank screen (best saving) or to two modes displaying "moving" parameters.
Parameters can be individually enabled or disabled. Available parameters are: UTC time, DATE, LOCAL
TIME and CALLSIGN. Callsign can be edited on screen, by default it is set to "microHAM".
SCREEN MODE
2.
Sets mode of the screen saver.
1 – blank screen
2 – slowly moving parameters
3 – flying parameters
Selected mode can be checked by navigating focus to TRY icon, turning knob to highlight it and pushing
EDIT button.
SLEEP
3.
Sets time of inactivity in minutes when SMΩRF enters into Sleep Mode. In the sleep mode SMΩRF turns
completely off internal RF board and as much as possible internal circuits. From the sleep mode SMΩRF
can wake up by pressing any button or knob. Sleep Mode is not entered if there is any active LAN
connection ongoing.
WAKEUP on LAN
4.
When enabled, SMΩRF can wake up from the Sleep Mode by "magic" packet received thru the LAN.
5.
WAKEUP on PTT
When enabled, SMΩRF can wake up from the Sleep Mode by sensing activity on PTT IN port.
microHAM © 2015 All rights reserved
SYSTEM MENU – POWER SAVING
43
Advertisement
Table of Contents
