Auto Mode; Dual Sensors Screen Templates - microHAM SMORF Manual

AUTO mode is a special operating mode of the SMΩRF which can be applied for any single sensor screen. In
AUTO mode, meter makes automatic sensor focus to the first sensor from which detects power. Unfocused
sensor is ignored and alarms for this sensor are not generated. When power samples from the focused sensor
disappear, meter restarts automatic sensing and switches focus again to the first sensor from which detects
power.
AUTO mode is activated by short push of SENSOR 1 and SENSOR 2 buttons together and is indicated by
flashing SENSOR 1 or SENSOR 2 according to last sensor focus. AUTO mode is canceled by pushing either
SENSOR1 or SENSOR 2 button.
AUTO mode is useful for multiband HF+VHF/UHF transceivers where meter automatically switches between
sensors according to operating band (HF vs VHF or UHF) or for SO2R contesting setups where only one
transceiver transmits at a time.
AUTO mode is not available in SINGLE RADIO/SINGLE SENSOR and SINGLE RADIO/SENSORS IN SERIES
METER MODES.
In following chapters we describe dual sensor SCREEN templates, their purpose of use, settings and all
available functions.
DUAL mode is activated by longer push and hold of SENSOR 1 and SENSOR 2 buttons together and is
indicated by both SENSOR 1 and SENSOR 2 indicators lit. DUAL mode is canceled by pushing either
SENSOR1 or SENSOR 2 button.
Please note, while single sensor screens can appear in any METER MODE, DUAL sensor screens are available
only in two METER MODES and are further filtered by particular meter mode selection (SYSTEM MENU |
METER MODE):
SINGLE RADIO, SENSORS IN SERIES
•
TWO INDEPENDENT RADIOS AND SENSORS
•
microHAM © 2015 All rights reserved

AUTO MODE

8 - DUAL SENSORS SCREEN TEMPLATES

31