ABB i-bus KNX Product Manual page 8
Light controller with sensor lr/s with lf/u, intelligent installation systems
Hide thumbs
Also See for i-bus KNX:
- Product manual (264 pages) ,
- Product manual (5 pages) ,
- Product manual (220 pages)
Table of Contents
Advertisement
®
ABB i-bus
KNX
© 2008 ABB STOTZ-KONTAKT GmbH
General
•
The 1-10 V control voltage is purely used for dimming the ballasts.
The devices remain under mains voltage, even at minimum brightness.
Isolation of the ballasts is carried out via the switch contact in the control
device.
•
The maximum loading of the control device must observed:
1. Loading of the 1-10 V control line.
2. Maximum switching capacity of the output circuit,
including consideration of in-rush currents.
6
Advertisement
Table of Contents
