ABB i-bus KNX Product Manual page 17

®
ABB i-bus KNX
Temperature range
Environmental conditions
Design
Weight
Mounting position
Housing, colour
Approvals
CE mark
1)
Note: Not suitable for Light Controller LR/S 2.2.1 and Light Controller Module LR/M 1.6.1
2)
Rooms are lit up differently by the incidental daylight and the artificial lighting of the lamps. Not all surfaces in the rooms, e.g. walls, floor,
and furniture reflect the light which falls on them in the same manner. Accordingly, even though there is an exactly calibrated constant
lighting control in daily operation, deviations to the set target value may occur. These deviations may be up to +/- 100lx should the current
ambient conditions in the room, and accordingly the reflection properties of the surfaces (paper, persons, reorganized or new furniture),
differ significantly from the original ambient conditions at the time of calibration. Deviations may also occur if the Light Sensor is influenced
by direct or reflected light falling on it which is not influenced or only slightly influenced by the surfaces in the detection range of the Light
Sensor.
© 2008 ABB STOTZ-KONTAKT GmbH
Device technology
Operation
Storage
Transport
Humidity
Flush mounted device
Dimensions
in kg
as required
Plastic housing, grey
KNX to EN 50 090-2-2
in accordance with the EMC guideline and low
voltage guideline
-5 °C ...+45 °C
-25 °C...+55 °C
-25 °C...+70 °C
Maximum 93 %, moisture condensation
should be excluded
For installation in 60 mm flush mounted box
54 x 20 (Ø x H)
0,04
Certificate, in conjunction with LR/S x.16.1
15