Parameter Window X: Slave - ABB i-bus KNX Product Manual

®
ABB i-bus KNX
3.2.14 Parameter window
X: Slave
© 2008 ABB STOTZ-KONTAKT GmbH
Commissioning
The parameter window X: Slave is enabled if in parameter window
the parameter Select additional function is set with the option
X: General
Slave mode in lighting control.
In slave mode the output of the Light Controller follows the brightness value
provided by the master output via the object Brightness value of slave.
In this way the output of another ABB i-bus
the constant lighting control of the Light Controller.
With the Light Controller it is possible to directly control a slave output
internally using a master output on the Light Controller. The brightness value
is assigned directly to the slave output in the Light Controller. This will avoid
unnecessary telegram traffic on the KNX. Of course the slave can also be
controlled via the external object X: Brightness value of slave. For this
purpose in the parameter window
Slave is controlled via to set to External via object.
If in the following the object Switch or Brightness value are mentioned,
it also applies for the objects Switch/Status or Brightness value/Status.
The following three parameters define how an output should react with
active slave mode.
®
device can be integrated into
you can find the parameters
X: Slave
76