ABB i-bus KNX Product Manual page 75

®
ABB i-bus KNX
Commissioning
32
The group object is enabled if the Switching bit or scene parameter is set to Switching bit in the Time switch Astro Plus –
Settings parameter window.
The object sends its value depending on the set application function for sending on the KNX bus on brightness or darkness.
The object value depends on the Time switch Astro Plus application parameter.
Telegram value:
33
The group object is enabled if the Time switch parameter is set to Active in the Time switch Standard – Settings parameter
window.
Telegram value:
34
The group object is enabled if the Date/time by receiver or bus value parameter is set to Bus (external) in the Time standard –
Date/Time parameter window.
The object is used to send the current date to the device if it does not come from the internal sensor.
35
The group object is enabled if the Date/time by receiver or bus value parameter is set to Bus (external) in the Time standard –
Date/Time parameter window.
The object is used to send the current time to the device if it does not come from the internal sensor.
36
The group object is enabled if the Temperature control depending on internal measurement or external bus value parameter is
set to Bus (external) in the Temperature – Temperature control parameter window.
The object is used to send the temperature for comparison with the setpoint temperature (temperature control) if it does not
come from the internal sensor.
Sending
0 = Darkness/brightness
1 = Brightness/darkness
Sending
0 = Darkness/brightness
1 = Brightness/darkness
Reception
Reception
Reception
Sends Astro Plus – Sending
Sends time switch Standard –
Sending
Receives date from bus –
Reception
Receives time from bus –
Reception
Receives temperature from
bus – Reception
1-bit C, T
DPT 1.001
1-bit C, T
DPT 1.001
3-byte C, W
DPT 11.001
3-byte C, W
DPT 10.001
1-byte C, W
DPT 9.001
TR/A 1.1 | 2CDC509082D0201 73