ABB i-bus KNX Product Manual page 30

®
ABB i-bus KNX
Commissioning
Send GPS state
Options:
This parameter can be used to decide when the state of GPS reception is to be sent on the bus.
•
Never: Sending on the bus is deactivated.
•
On change: The 1-bit object Sends TR/A 1.1 state (0=OK; 1= not OK) – Sending is activated. The
value 0 is sent on this object if the GPS signal is received correctly; the value 1 is sent on this object if
there was no reception for the time parameterized in the Send GPS state parameter. Sending takes
place only on the change between reception (0) and no reception (1).
•
On change and automatically/cyclically: The 1-bit object Sends TR/A 1.1 state (0=OK; 1= not OK) –
Sending is activated. The value 0 is sent on this object if the GPS signal is received correctly; the value
1 is sent on this object if there was no reception for the time parameterized in the Send GPS state
parameter. Sending takes place only on the change between reception (0) and no reception (1).The
dependent parameter Cycle interval for GPS state is additionally activated.
28 2CDC509082D0201 | TR/A 1.1
Never
On change
On change and automatically/cyclically
Cycle interval for GPS state
Options: Every 30 seconds
Every minute
Every hour
Every 6 hours
Every 12 hours
At midnight
At 00:02
Depending on the selection, the GPS state is correspondingly sent cyclically on the bus.