ABB i-bus KNX Product Manual page 49

®
ABB i-bus KNX
Commissioning
Enable blocking object
Options:
A 1-bit object to block brightness control can be enabled with this object. If brightness control is blocked,
the output object is no longer changed until the block is canceled, even if the brightness exceeds/falls
below the parameterized thresholds.
•
•
No
Yes
No: The blocking object is deactivated.
Yes: The blocking object Light control blocking object threshold 1 – Reception is enabled.
The following dependent parameters are additionally enabled.
Evaluation of the blocking object
Options: Block on 1
Block on 0
This parameter is used to set the condition under which brightness control is blocked.
•
Block on 1: Brightness control is blocked when a 1 is received on the input object.
A 0 cancels the block again.
•
Block on 0: Brightness control is blocked when a 0 is received on the input object.
A 1 cancels the block again.
State after reset
Options: Enabled
Blocked
The parameter is used to define whether brightness control is to be blocked or enabled after an
ETS reset.
•
Enabled: Brightness control is enabled after ETS reset.
•
Blocked: Brightness control is blocked after ETS reset.
TR/A 1.1 | 2CDC509082D0201 47