ABB i-bus KNX Product Manual page 54

®
ABB i-bus KNX
Commissioning
52 2CDC509082D0201 | TR/A 1.1
Reaction on removing the block
Options: Send current value
No action
The parameter defines the brightness control reaction when the block is canceled.
•
Send current value: The currently valid brightness control value is sent.
•
No action: The object does not send its current status automatically, but only after the
next change.
Reaction on setting the block
Options: No action
Send a telegram
The parameter defines the brightness control reaction when the block is set.
•
No action: The object sends nothing and is blocked.
•
Send a telegram: A telegram is sent on the bus via the object Sends light above/below
threshold 2 – Sending or Sends scene light above/below threshold 2 – Sending when the
block is set. The dependent parameter Telegram on setting the block is enabled.
Telegram on setting the block
The parameter options depend on the selected Switching bit or scene parameter.
The following options are available if Switching bit was selected:
Options:
•
0: The value 0 is sent
•
1: The value 1 is sent
The following values are available if scene was selected.
Options:
The selected scene number is sent on the bus when the block is activated.
0
1
1 ... 64