Writing The Project Data And Os Onto The Got - Mitsubishi Electric GOT1000 Series Connection Manual

1.2 Writing the Project Data and OS onto the GOT

Write the standard monitor OS, communication driver, option OS, project data and communication settings onto the GOT.
For details on writing to GOT, refer to the following manual.
GT Designer3 Version1 Screen Design Manual
1.2.1

Writing the project data and OS onto the GOT

1.
Select [Communication]
2.
The [Communication configuration] dialog box appears.
Set the communication setting between the GOT and the personal computer.
Click the [OK] button when settings are completed.
3.
The [GOT Write] tab appears on the [Communicate with GOT] dialog box.
Select the [Project data, OS] radio button of the Write Data.
4.
Check-mark a desired standard monitor OS, communication driver, option OS, extended function OS, and
Communication Settings and click the [GOT Write] button.
POINT POINT POINT
Writing communication driver onto GT10
When writing a communication driver onto the GT10 in which a Boot OS Ver. under F or a standard monitor OS
Ver. under 01.08.00 is written, turn on the GOT in the OS transfer mode.
Also, even when the communication port to be used for transferring is assigned to Ch9, turn on the GOT in the OS
transfer mode.
For details, refer to the following manual.
GT10 User's Manual
(Operating of transmission mode)
[Write to GOT...] from the menu.
Turn on the GOT while the bottom right corner is touched.
1. PREPARATORY PROCEDURES FOR MONITORING
1.2 Writing the Project Data and OS onto the GOT
1
2
3
4
5
6
7
8
1 - 13