System Alarms And Events - ABB 800xA User Manual

Section 5 Maintenance
3.
4.
After the restore of the subscriber node, restart the Remote Access Client. You can
perform this task by killing the AfwRAC process from the task manager.
A restore of the Remote Access Client service is necessary for the uploaded
objects to work. Without a valid backup of the Remote Access Client, the
provider system must be uploaded again to the subscriber system.

System Alarms and Events

800xA generates a number of system alarms and events.
conditions they are generated.
Description
Host '%HOST%'
disconnected.
Connection to
'%HOST%'
accepted.
The node
'%HOST%' could
not be accepted
(incorrect
password).
No user mapping
for remote user
'%USER
3BSE037076-510 D
Select the Restore tab and check the Remote Access Client check box and
Unit 0; click Apply.
Click the Restore button to finish the restore.
Message
Connection from the RAC to the RAS broken. This alarm is
generated both in the subscriber and provider end.
Connection established from the RAC to the RAS. This event
is generated in the subscriber and provider end.
Connection refused due to wrong password. This event is
generated in both ends.
No user mapping found when an attempt to perform an
operation was done. This event is generated in both ends.
Table 5. System Messages
Extended Description
System Alarms and Events
Table 5 shows under what
89