ABB 800xA User Manual page 45

Section 3 Configuration
•
•
•
When an aspect is copied from the provider system to the subscriber system,
references to other uploaded objects and aspects are also changed. This means
that an uploaded aspect is not a binary copy of the original aspect. The aspect
system for the copied aspect must be installed both on the provider and the
subscriber system and support the 800xA Multisystem Integration System
Extension.
If structures are added and uploaded but later removed from the upload
configuration, in some cases, objects will be left in the subscriber. These objects will
not work correctly. To get a correct set of uploaded objects, run Clean and make a
new upload before going into operation with the subscriber.
Clean command will not remove the object ID mappings for the uploaded
objects. A new upload will continue to have the same object ID as the previous
upload, so the displays in the subscriber system that has references to the provider
objects will be valid after a clean and a new upload.
Provider Services
If a more detailed system status for the provider system is needed in the subscriber
the complete service structure in the provider should be uploaded. Navigate to the
Service Structure in the upload browser and select the "Services" object. Include
children and references and upload to the Control Structure in the subscriber. The
system status can be viewed in the system status viewer aspect also uploaded from
the provider.
3BSE037076-510 D
Ignore at upload
The aspect is not uploaded to the subscriber system. Useful when an aspect
category defines OPC properties that should be excluded when creating proxy
aspects.
Copy at upload
The aspect is copied from the provider to the subscriber system.
Create a proxy aspect
A control connection, log configuration, or log template proxy is created.
Upload Configuration
45