Rear Ballast - Toro greensmaster 3100 Operator's Manual

1. Ball joint
2. Pull arm
3. Jam nut
6. Align the sockets in the ball joints so the open
side of the socket is centered toward the ball
stud. Tighten the jam nuts to secure the sockets
in position (Fig. 6).
7. Assemble the mounting capscrews for the reel
drive motor to each cutting unit. Leave
approximately 1.2cm of thread exposed on each
mounting capscrew (Fig. 7).
1. Capscrews
2. Drive motor
8. Remove the protective covers from the cutting
units and the reel drive motor shafts.
Note: Retain the protective covers for the cutting
units. Install them whenever the reel drive
motors are removed to protect the cutting unit
bearings from contamination.
9. Using a hand pump grease gun, fill the cavity at
the end of the cutting unit with #2 general
purpose grease.
Figure 6
Figure 7
10. Coat the spline shaft of the motor with clean
grease and install the motor by rotating the motor
clockwise so that the motor flanges clear the
studs. Rotate the motor counterclockwise until
the flanges encircle the studs, then tighten the
mounting capscrews (Fig. 7).

Rear Ballast

This unit complies with the ANSI B71.4-1999
Standard when 40 lbs. of calcium chloride ballast is
added to the rear wheel.
Important
If a puncture occurs in a tire with
calcium chloride, remove the unit from the turf area as
quickly as possible. To prevent possible damage to
turf, immediately soak the affected area with water.
12