Adjusting The Lift And Mow Pedal Height; Leveling The Lift And Mow Pedals; Adjusting The Traction Pedal - Toro greensmaster 3100 Operator's Manual

mow pedal height.
Adjusting the Lift and Mow Pedal
Height
Adjust the lift and mow pedal to equal height to gain
proper spool travel in the valve bank as follows:
1. Place 1, 2 and 3 spools in neutral (center of
travel) and remove the transfer rod guard from
the foot panel.
2. Loosen the jam nut securing the yoke on the
front of the long control rod; remove the cotter
pin and clevis pin.
3. Move the adjustment lever by hand to level the
mow and lift the pedals and adjust the yoke on
the control rod until the hole in the yoke lines up
with the adjustment lever hole.
1. Transfer rod guard
4. Install the clevis pin and cotter pin. Tighten the
jam nut and install the transfer rod guard.
5. Actuate the mow pedal by hand. Be sure the lift
pivot under the pedals clears the stop welded to
the frame, thereby allowing full spool travel.
1
Figure 41
4
1. Jam nut
2 Yoke
3. Control rod
4. Adjustment lever

Leveling the Lift and Mow Pedals

If the lift and mow pedals are not level when in the
neutral position, an adjustment to the lift pivot is
required.
1. Loosen the nut on the back side of the lift pivot.
2. Rotate the eccentric screw to raise or lower the
lift pivot spring, leveling the lift pivot and
pedals.
2
1. Lift Pivot
2. Eccentric Screw
3. While holding the screw, tighten the nut to lock
the adjustment.

Adjusting the Traction Pedal

To check forward and reverse operation of the traction
pedal, proceed as follows:
33
1 3
2
Figure 42
1
Figure 43