Storage; Identification And Ordering - Toro greensmaster 3100 Operator's Manual

Storage

If you wish to store the Greensmaster 3100 for a long
period of time, take the following steps before
storage:
1. Remove accumulations of dirt and old grass
clippings. Sharpen the reels and bedknives, if
necessary; refer to the cutting unit operator's
manual. Use a rust preventive on bedknives and
reel blades. Grease and oil all lubrication points:
refer to Lubrication.
2. Block up wheels to remove the tire weights.
3. Drain and replace the hydraulic fluid and filter,
inspect hydraulic lines and fittings. Replace, if
necessary; refer to Changing Hydraulic Oil and
Filter and Checking Hydraulic Lines and Hoses.
4. All fuel should be removed from the fuel tank;
run the engine until it stops from lack of fuel.
The small amount of fuel that remains in the
bottom of the tank should be removed by
absorbing it with a clean dry cloth. Replace the
fuel filter; refer to Fuel Filter Replacement.
5. While the engine is still warm, drain oil from the
crankcase. Refill with fresh oil; refer to
Changing Engine Oil and Filter.
6. Remove the spark plugs, pour 3cl of SAE 30 oil
into the cylinders and crank slowly to distribute
the oil. Replace the spark plugs; refer to
Replacing Spark Plugs.
7. Clean dirt and chaff from the cylinder, cylinder
head fins and blower housing.
8. Remove the battery and charge it fully. Either
store it on the shelf or on the machine. Leave the
cables disconnected if stored on the machine.
Store the battery in a cool atmosphere to avoid
quick deterioration of the charge in the battery.
9. If possible, store in a warm, dry location.

Identification and Ordering

Model and Serial Numbers
The Greensmaster 3100 has two identification
numbers: a model number and a serial number. The
two numbers are stamped on a plate, which is riveted
on the right inside of the footr est support. In any
correspondence concerning the Greensmaster 3100,
supply the model and serial numbers to be sure that
you obtain correct information and replacement parts.
To order replacement parts from an authorized TORO
distributor, supply the following information:
1. Model and serial numbers of the machine.
2. Part number, description and quantity of parts
desired.
Note: Do not order by reference number if a parts
catalog is being used; use the part number.
44