Transport Operation; Inspection And Clean-Up After Mowing - Toro greensmaster 3100 Operator's Manual

Transport Operation

Make sure the cutting units are in the highest UP
position. Set the shift selector in No. 2 if conditions
will permit faster ground speed. In rough or hilly
areas, shift to No. 1 and operate at slower ground
speeds. Use the brakes to slow the machine while
going down steep hills to avoid loss of control.
Always approach rough areas at a reduced speed (shift
selector in No. 1), and cross severe undulations
carefully. Familiarize yourself with the width of the
machine. Do not attempt to pass between objects that
are close together so that you can prevent costly
damage and down time.
Inspection and Clean-Up After
Mowing
After mowing, thoroughly wash the machine. Use a
garden hose without a nozzle so excessive water
pressure doesn't contaminate and damage seals and
bearings. After cleaning, inspect the machine for
possible hydraulic fluid leaks, damage or wear to the
hydraulic and mechanical components. Also check
the cutting units for sharpness. Lubricate the mow
and lift pedal and the brake shaft assembly with SAE
30 oil or spray lubricant to deter corrosion and keep
the machine performing well during the next mowing
operation.
23