Mow/Lift Switch Maintenance; Adjusting The Traction Return Linkage; Battery Care - Toro greensmaster 3100 Operator's Manual

the jam nut is over-tightened.
8. Connect a continuity tester or ohm meter to the
switch terminals and move shift selector to the
#1 and #2 positions. There should not be
continuity when the shift selector is in either of
these positions. If there is continuity, repeat
steps 5 and 6.
9. Move the shift selector lever to neutral and
connect a continuity tester or ohm meter to the
switch terminals. The switch should show
continuity. This means the switch is operating
correctly.
10. Plug the switch connectors together.

Mow/Lift Switch Maintenance

Important
Spool travel for 1, 2 and 3 spools must
be correct before the mow/lift switch can be adjusted.
Refer to Rear Camshaft Adjustment.
1. Pivot the seat forward and secure it with the
support rod to prevent it from falling accidentally
and causing injury.
2. Unplug the switch connectors from the end of the
mow/lift switch installed in the valve bank
bonnet.
3. Loosen the jam nut and unscrew the switch from
the valve bank bonnet.
4. While holding the lift pedal in a fully depressed
position (valve bank spools fully IN), partially
screw the new switch into the bonnet.
5. Connect a continuity tester or ohm meter across
the switch terminals and turn the switch in until
continuity occurs. Then rotate the switch in 1/2
turn (180 degrees) and secure the jam nut to 75
in-lb. against the bonnet.
Important
. Switch threads will be damaged if
the jam nut is over-tightened.
6. Connect a continuity tester or ohm meter to the
switch terminals and depress the mow pedal.
There should not be continuity. If there is
continuity, repeat step 4. Go to step 7 if there is
no continuity.
7. Depress the lift pedal and release it (neutral
position). The switch circuit should have
continuity.
8. Plug the switch connectors together.
Adjusting the Traction Return
Linkage
If the shift selector lever does not return to the neutral
or #1 position from the #2 position when the mow
pedal is engaged, an adjustment to the traction return
linkage is required.
1. Loosen the front jam nut securing the cable
assembly to the mow/lift control rod bracket.
2. Move the shift lever to the #1 position.
3. While holding the mow/lift control rod in the
rear position, tighten the rear locknut to remove
almost all slack from the cable assembly. Do not
over-tension the cable.
4. Tighten the front jam nut to lock adjustment.
5. Check operation and re-adjust as required.
1. Cable assembly
2. Mow/lift control rod bracket
3. Mow/lift control rod

Battery Care

1. Battery electrolyte level must be properly
maintained and the top of the battery kept clean.
36
Figure 47