Parameter Copy And Parameter Verification; Parameter Copy - Mitsubishi Electric F700 Instruction Manual

Parameter copy and parameter verification

4.25 Parameter copy and parameter verification
PCPY Setting
0
1
2
3
REMARKS
· When the copy destination inverter is not the FR-F700 series or parameter copy write is performed after parameter copy read is
stopped, "model error (
· Refer to the parameter list on
· When the power is turned off or an operation panel is disconnected, etc. during parameter copy write, perform write again or check the
values by parameter verification.

4.25.1 Parameter copy

Multiple inverters and parameter settings can be copied.
1.
Connect the operation panel to the
copy source inverter.
• Connect it during a stop.
2.
Press
setting mode.
3.
Turn until
appears.
4.
Press to to read the currently set value.
" "(initial value) appears.
5.
Turn to change it to
the setting value " ".
6.
Press
to the operation panel.
7.
Connect the operation panel to the
copy source inverter.
8.
After performing steps 2 to 5,
turn to change it to "
9.
Press
the operation panel to the destination inverter.
10.
When copy is completed,
" " and "
11.
After writing the parameter values to the copy
destination inverter, always reset the inverter,
e.g. switch power off once, before starting operation.
228
Cancel
Copy the source parameters to the operation panel.
Write the parameters copied to the operation panel into the destination inverter.
Verify parameters in the inverter and operation panel. (Refer to page 229.)
)" is displayed.
page 288 and later for availability of parameter copy.
Operation
to choose the parameter
(parameter copy)
to copy the source parameters
".
to write the parameters copied to
" flicker.
Description
About 30s later
Flicker ··· Parameter copy complete!!
Flicker ··· Parameter copy complete!!
Display
The parameter
number previously
read appears.
The frequency flickers
for about 30s
The frequency flickers
for about 30s