Parameter Copy And Parameter Verification; Parameter Copy - Mitsubishi Electric FR-A720-00030-NA Instruction Manual

4.29 Parameter copy and parameter verification

PCPY Setting
0 Cancel
1 Copy the source parameters to the operation panel.
2 Write the parameters copied to the operation panel into the destination inverter.
3 Verify parameters in the inverter and operation panel. (Refer to page 406.)
REMARKS
· When the copy destination inverter is not the FR-A700 series or parameter copy write is performed after parameter copy read is
stopped, "model error (
· Refer to the parameter list on page 472 and later for availability of parameter copy.
· When the power is turned OFF or an operation panel is disconnected, etc. during parameter copy write, perform write again or
check the values by parameter verification.
· Initial settings of certain parameters are different for different capacities, so some parameter settings may be automatically
changed when parameter copy is performed from a different-capacity inverter. After performing a parameter copy from a
different-capacity inverter, check the parameter settings. (Refer to the parameter list (page 96) for the parameters with different
initial settings for different capacities.)

4.29.1 Parameter copy

Parameter settings can be copied to multiple inverters.
Connect the operation panel to the copy source inverter.
1.
Connect it during a stop.
Parameter setting mode
2.
Press to choose the parameter setting mode. (The parameter number read previously appears.)
Selecting the parameter number
3.
Turn until "
appears.
Copying to the operation panel
Turn to change it to the setting value "
4.
(" " flickers for about 30s.)
" " and "
5.
Connect the operation panel to the copy source inverter.
6.
After performing steps 2 and 3, turn
Writing to the inverter
7.
Press to write the parameters copied to the operation panel to the destination inverter. ("
" " and "
After writing the parameter values to the copy destination inverter, always reset the inverter,
8.
e.g. switch power off once, before starting operation.
appears...Why?
appears...Why?
and
Appears when parameters are copied between the inverter of FR-A720-02150 (FR-A740-01100) or lower and
FR-A720-02880 (FR-A740-01440) or higher.
1. Set "0" (initial value) in Pr. 160 User group read selection.
2. Set the following setting (initial value) in Pr. 989 Parameter copy alarm release.
Pr. 989 Setting
3. Reset Pr. 9, Pr. 30, Pr. 51, Pr. 52, Pr. 54, Pr. 56, Pr. 57, Pr. 61, Pr. 70, Pr. 72, Pr. 80, Pr. 82, Pr. 90 to Pr. 94 , Pr. 158,
Pr. 455, Pr. 458 to Pr. 462, Pr. 557, Pr. 859, Pr. 860, Pr. 893.
)" is displayed.
" (parameter copy) appears. Press
". Press
" flicker alternately after parameters are copied.
to change it to "
" flicker alternately after parameters are copied.
Parameter read error. Perform operation from step 3 again.
Parameter write error. Perform operation from step 6 again.
flicker alternately
FR-A720-02150 (FR-A740-01100)
lower
10

Parameter copy and parameter verification

Description
Operation
to read the currently set value. "
to copy the source parameters to the operation panel.
".
FR-A720-02880 (FR-A740-01440)
or
" (initial value)
" flickers for about 30s.)
or
higher
100
4
405