Engine Cooling Fan Motor Service - Toro Groundsmaster 4100-D Service Manual

Engine Cooling Fan Motor Service

3
14
7
1
5
4
1. Flange washer
2. O- -ring
3. Front flange
4. Dust seal
5. Retaining ring
6. Front wear plate
Disassembly (Fig. 81)
1. Plug motor ports and clean the outside of the motor
thoroughly. After cleaning, remove plugs and drain any
oil out of the motor.
2. Use a marker to make a diagonal line across the
front flange and body for assembly purposes (Fig. 82).
IMPORTANT: Prevent damage when clamping the
fan motor into a vise; clamp on the front flange only.
Also, use a vise with soft jaws.
3. Clamp front flange of motor in a vise with soft jaws
with the shaft end down.
4. Loosen four (4) cap screws (item 13).
5. Remove motor from the vise. Turn motor so that the
shaft end is facing down. Remove cap screws.
6. Carefully remove body. Lift body straight up to re-
move. Make sure the rear wear plate remains on the
drive and idler gear shafts. Remove and discard O--
rings from the body. Locate and retrieve dowel pins.
Hydraulic System
6
8
9
2
14
Figure 81
7. Shaft seal
8. Backup gasket
9. Pressure seal
10. Rear wear plate
11. Body
Page 4 - - 118
10
15
8
12
IMPORTANT: Note position of the open and closed
side of the wear plates before removing. Also, iden-
tify wear plates (front and rear) with a marker for
proper assembly.
7. Carefully remove rear wear plate, idler gear, drive
gear and front wear plate from the front flange.
11
9
12. Idler gear
13. Cap screw (4 used)
14. Dowel pins (2 used)
15. Drive gear
16. Washer (4 used)
MARKER LINE
Figure 82
Groundsmaster 4100--D/4110--D
13
16
33 ft- -lb
(45 N- -m)