Toro Groundsmaster 4100-D Service Manual page 34

9. Connect throttle cable to injector pump (Figs. 13 and
14):
A. Secure throttle cable swivel to speed control le-
ver with lock nut.
B. Place throttle cable under cable clamp.
C. Adjust throttle cable position in cable clamp so
that engine governor lever contacts the high speed
stop bolt at the same time that the throttle lever con-
tacts the end of the slot in the control console.
D. Tighten cable clamp to secure throttle cable.
10.Connect fuel line to the injection pump (Fig. 13).
11. On Groundsmaster 4110--D machines:
A. Position windshield washer reservoir to bracket
reservoir mount on engine (Fig. 16). Secure with re-
moved fasteners.
B. Install air conditioning compressor to brackets
(see Air Conditioning Compressor Installation in the
Service and Repairs section of Chapter 9 -- Operator
Cab). Make sure that drive belt is properly tensioned.
C. Connect coolant hose to fitting on engine water
flange.
12.Connect wires and/or electrical connections to the
following electrical components:
A. The temperature sender and alternator (Fig 11).
B. The engine run solenoid.
C. The glow plug lead (Fig. 12).
D. Battery, frame and wire harness ground to the en-
gine block.
E. The starter and low oil pressure switch (near
starter).
F. The air conditioning compressor (Groundsmas-
ter 4110--D machines).
Kubota Diesel Engine
13.Install air cleaner assembly to the engine (see Air Fil-
ter System Installation in this section).
14.Install exhaust system to machine (see Exhaust Sys-
tem Installation in this section).
15.Connect coolant hoses to the radiator. Make sure ra-
diator drain is shut. Fill radiator and reservoir with cool-
ant.
16.Check position of wires, fuel lines, hydraulic hoses
and cables for proper clearance with rotating, high tem-
perature and moving components.
17.Install battery to machine (see Battery Service in the
Service and Repairs section of Chapter 5 -- Electrical
System). Make sure to connect positive battery cable
first and then negative battery cable. Secure battery to
machine with strap and cover.
18.Check and adjust engine oil as needed.
19.Check and adjust hydraulic oil as needed.
20.Bleed fuel system.
21.Start engine and operate hydraulic controls to prop-
erly fill hydraulic system (see Charge Hydraulic System
in the Service and Repairs section of Chapter 4 -- Hy-
draulic System).
22.Close and secure hood.
Page 3 - - 16 Groundsmaster 4100--D/4110--D