Toshiba e-STUDIO200L Service Manual page 264

[J] Drum separation finger
(1) Take off the drum
( P.11-13 "[H] Drum").
(2) Remove 1 screw of each unit to take off the
drum separation finger units (3 pc.).
Notes:
1. When replacing the drum separation fin-
gers, make sure that the drum has been
taken off first since the fingers may
scratch the drum surface.
2. In e-STUDIO202L/203L/232/233/232S/
282/283/282S/283S, 2 drum separation
finger units are installed.
(3) Remove the spring and take off the drum
separation fingers.
Note:
When the drum separation fingers have been
replaced, check if the pressure movement is
normal by moving them with your hands.
[K] Recovery blade
(1) Take off 3 drum separation finger units
( P.11-14 "[J] Drum separation finger").
(2) Remove 2 screws, and take off the whole
recovery blade with the bracket.
e-STUDIO200L/202L/203L/230/232/233/280/282/283
DRUM RELATED SECTION
Drum separation finger unit
Drum separation finger
Recovery blade
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved
11 - 14
07/11
Fig. 11-20
Fig. 11-21
Fig. 11-22