Set Dial Tone Detection; Set Telephone Line Compatibility For Interference And Voip Systems - Dell E515dw User Manual

Sent faxes are blank.
Vertical black lines when sending.
Printing received faxes
Difficulties
• Condensed print
• Horizontal streaks
• Top and bottom sentences are cut off
• Missing lines
Vertical black lines when receiving
Received faxes appear as split or blank
pages.

Set Dial Tone Detection

Related Models:Dell E515dn / Dell E515dw
1. Setting the Dial Tone to Detection will shorten the Dial Tone detect pause.
2. Press Menu.
3. Press p or q to display the Initial Setup option, and then press OK.
4. Press p or q to display the Dial Tone option, and then press OK.
5. Press p or q to choose the Detection or No Detection, and then press OK.
6. Press Cancel.

Set Telephone Line Compatibility for Interference and VoIP Systems

Related Models:Dell E515dn / Dell E515dw
Problems sending and receiving faxes due to possible interference on the telephone line may be solved by lowering
the modem speed to minimize errors in fax transmission. If you are using a Voice over IP (VoIP) service, Dell
recommends changing the compatibility to Basic (for VoIP).
NOTE: VoIP is a type of phone system that uses an Internet connection, rather than a traditional phone line .
268 Troubleshooting
Make sure you are loading the document correctly. When using the ADF, the
document should be face up. When using the scanner glass, the document
should be face down.
Black vertical lines on faxes you send are typically caused by dirt or correction
fluid on the glass strip. Clean the glass strip.
Suggestions
This is usually caused by a poor telephone connection. Make a copy; if your copy
looks good, you probably had a bad connection, with static or interference on the
telephone line. Ask the other party to send the fax again.
The corona wire for printing may be dirty.
Clean the corona wire in the drum unit.
The sender's scanner may be dirty. Ask the sender to make a copy to see if the
problem is with the sending machine. Try receiving from another fax machine.
Left and right margins are cut off or a single page is printed on two pages.
Turn on Auto Reduction.