Zone List Programming - Honeywell ADEMCO VISTA SERIES VISTA-21iP Installation And Setup Manual

Installation and Setup Guide

Zone List Programming

1. Select an appropriate zone list number.
2. Add the desired zone numbers to be included in that list.
Start Zone List Program Mode by pressing
*81 Menu Mode
Zone List No.
(00 = Quit) 01
01 Enter Zn Num.
(00 = Quit) 00
01 Del Zn List?
0 = No 1 = Yes 0
01 Delete Zone?
0 = No 1 = Yes 0
01 Zn to Delete?
(00 = Quit) 00
5-14
✱
81 while in Data Programming mode.
Zone List Number
01-12 = zone list number; [ ∗ ] to continue
Enter the Zone List Number to program (or 00 to quit). Press [ ✱ ] to advance.
In the following displays, zone list 01 has been selected for programming.
Zone Number
01-64 = zone numbers followed by [ ∗ ] to accept each zone; 00 to continue
Enter each zone number to add to the zone list, followed by pressing [ ✱ ] (example, 01 ✱ ,
02 ✱ , 03 ✱ ). After all zones are entered, press 00 to continue.
IMPORTANT: Do not include fire zones in zone lists that are used to STOP device actions.
Deleting Zone Lists
0 = don't delete list; 1 = delete this zone list; [ ∗ ] to continue
To delete the zone list, enter 1. All zones in the zone list will be deleted automatically and
the system returns to the Zone List No. prompt.
To save the zone list, enter 0.
Deleting a Zone
0 = don't delete zones; 1 = go to next prompt to delete zones; [ ∗ ] to continue
To save the zone list, enter 0 and the system returns to the Zone List No. prompt.
To delete a zone or zones in a zone list, enter 1 to continue.
Delete the Zone
01-64 = zones to be deleted from list followed by [ ∗ ] to accept each zone; 00 to continue
Enter each zone to be deleted from the list, followed by [ ✱ ]. After all zones to be deleted are
entered, enter 00 to return to the Zone List No. prompt so that another list can be
programmed, if desired.