Signal Strength And Status Led Locations - Status Led Functions Table - Honeywell ADEMCO VISTA SERIES VISTA-21iP Installation And Setup Manual

Signal Strength and Status LED Meanings
Color Label Indication
Red RSSI on = signal strength (RSSI) display
off = status display
Yel (2) mode off = module operating in ECPmode
Green Web web connection status
ON = connected to web
OFF = no web connection
Green GPRS GPRS service availability
ON = GPRS service available
FLASH = GPRS in use
OFF = no GPRS service (messages sent via SMS)
Green GSM network carrier registration status
ON = registered with network carrier, no second site available
FLASH = registered with network carrier and second site available, excellent RSSI
BLINK = registered with network carrier and second site available, acceptable RSSI
SLOW BLINK = registered with network carrier and second site available, low RSSI
OFF = control not registered with network carrier
VISTA-21iP CONTROL BOARD
RJ45 IP (WEB)
GRN
NETWORK
CONNECTOR GRN
LEDs
YEL
ON
INTERNAL/EXTERNAL
IP/GSM
POWER JUMPER
OFF
IP/GSM SWITCHES
TEST STATUS
AC AC BELL GND
1 2
3 4
Inadequate Signal
If sufficient signal strength cannot be achieved, take one of the following actions:
Strength;
1. Try relocating the cabinet to an area with better reception.
Using Stand-Alone
2. If moving the cabinet cannot achieve sufficient signal strength, an external, stand-alone
Communication
communication device (ex. GSMV4G) can be used. Follow these steps:
Device
a. Power down the control.
b. Remove the Internet cable from the RJ45 connector
c. Connect the communication device to the control's
d. Power up the control and the communication device.
e. Refer to ∗29 Menu mode, Enable INT IP/GSM prompt, for programming information.
f. Refer to the Installation and Setup Guide included with the communication device for the
ETHERNET LINK/ACTIVITY (ON=YES; OFF=NO)
LINK SPEED (ON=100 MB/S; OFF=10 MB/S)
NETWORK COLLISION (BLINK=DETECTED; OFF= NORMAL)
IP/GSM STATUS LEDs
STATUS
GRN
MESSAGE
YEL
FAULT
RED
VISTA-GSM4G MODULE
LED
INDICATOR
AUX GRN YEL Z1+ Z1- GND Z2
10
8 9 11
5 6 7
Signal Strength and Status LED locations – Status LED Functions Table
(if connected) and disable the Internal IP/GSM
portion of the control board by moving the
Internal/External IP/GSM Jumper to the OFF pair
of pins.
ECP terminals and complete all other
communication device wiring as required.
registration procedure.
RED
ON
YEL
MINIMUM
YEL
LIT
GRN
GRN
GRN
STATUS LED INDICATIONS
GRN SLOW
LEDs OFF BLINK
WEB NO WEB
CONNECTION
† †
GPRS NO GPRS
SERVICE
GSM MODULE NOT REGISTERED
REGISTERED LOW
RSSI
†
REGISTERED w/ NETWORK CARRIER AND 2nd SITE AVAILABLE
† †
IF NO GPRS, MESSAGE SENT VIA SMS
Z3 GND Z4 Z5 GND Z6 Z7 GND
12 13 14 15 16 17 18 19
Programming Overview
MAC ID LABEL
BLINK FLASH ON
CONNECTED
TO WEB
GPRS IN GPRS SERVICE
USE AVAILABLE
† † †
REGISTERED REGISTERED REGISTERED
ACCEPTABLE EXCELLENT NO 2nd SITE
RSSI RSSI AVAILABLE
Z8 TIP RING TIP RING GND
20 21 22 23 24 25
V21iP-018-V2
RJ-45
CONNECTOR
JUMPER IN OFF POSITION
V21iP-012-V0
2-19