Ignoring Alarms From Other Sites While Monitoring A Site; Figure 6-5 Live Alarmed Toolbar Details - Honeywell Rapid Eye Operator's Manual

Alarms from Events
Checkmark indicates that
the Launch Retrieval on
Selection from Alarm List
option is enabled.

Ignoring Alarms from Other Sites while Monitoring a Site

80
Figure 6-5 Live Alarmed Toolbar Details
Create Stop the ringing of alarm bell button. Button
a clip can also ACK ALL if the Automaticaly
Acknowledge Alarms option is selected.
List of alarms
Automatic Record for Live Alarm. Recording a clip starts immediately when an alarm is
received at the operator's PC.
Accept Alarm Callbacks. Setting for PCs designated as Multi-Media alarm stations.
Set Limit of Callbacks to [ n ]. Where n is the maximum number (from 1 to 16) of units
from which callbacks are accepted before more are turned away to call other alarm stations.
Automatic Clip Creation on Alarm Callback. Set to have clips created automatically when
an alarm callback occurs. This option is enabled by default.
Pre/Post -Trigger Duration (in seconds). Enter the number of seconds before and after an
alarm trigger that the automatically created clip will encompass. The default duration is 5
seconds.
Clip file Location. Specify the location where automatically created clips will be stored.
Ensure that the location exists before setting it. A folder created when the applications were
installed is selected as the clip file location by default.
Requirements
The Set Limit of Callbacks to [ n ] and Accept Alarm Callbacks options have no effect if:
• A PC is not designated as a Multi-Media alarm station. See the
Multi-Media Digital Video System Administrator
station.
- or -
• An alarm station operator has logged in to View using an account that does not hold
the right to process alarms.
The alarm handling options include Treat any Connection as Callback (of an alarm). An
operator of a Multi-Media alarm station can set this to count a connection to a unit as adding
a callback.
1. From a Multi-Media alarm station, use the View application to click the Alarm
Handling command, under Options in the View menu.
2. Select Accept Alarm Callbacks.
3. You have the option to set the callback limit (see
4. Select Treat any Connection as Callback. Click OK.
5. Close and then re-launch View.
Rapid Eye™
Guide, to set up a Multi-Media alarm
Table 6-1 for values).