Table of Contents
Advertisement
Configuration
You can save your System Event changes by highlighting Save and pressing
Selecting Cancel exits the screen without saving the changes.
Event Status Screen
Highlight Event Status in the Event menu and press
appears.
The Event Status screen displays the status of the DVR's systems and inputs. Events
will be highlighted, and related channels or events will flicker for five seconds when
detected.
Alarm-In, Motion, Video Loss and Text-In will be highlighted when each event is
detected based on the settings you made in the Alarm-In, Motion Detection and Text-In
setup screen on the Event menu.
Check Alarm-In and Check Recording will be highlighted when each event is detected
based on the settings you made in the System Event setup screen on the Event menu.
Panic Record will be highlighted while the DVR is in the panic recording mode.
Disk Almost Full will be highlighted when the DVR is not in the Recycle mode and the
level of disk usage reaches the Disk Almost Full percentage you made in the System
Event setup screen on the Event menu. Disk Full will be highlighted when the DVR is
not in the Recycle mode and all available storage space has been used.
Highlighting the Storage tab will display the hard disk drive status. Refer to the Storage
Screen section for details.
Rev 1.00
Figure 3-79
Event Status Screen
78
. The Event Status screen
Document 900.0856
.
12/06
Advertisement
Table of Contents
