Figure 3-26 Port Numbers Setup Screen - Honeywell HRXD9 User Manual

Configuration
Change the numbers by highlighting them and using the Up and Down arrow buttons
to increase or decrease the number.
The factory default Port settings are:
Caution
Selecting DHCP from the Type and highlighting Save reads the current IP address of
the DVR configured by DHCP (Dynamic Host Configuration Protocol) network.
Rev 1.00
Figure 3-26
Remote Admin:
Remote Callback:
Remote Watch:
Remote Search:
Note The system restarts automatically after changing the port
settings.
Note Do NOT use the same port number for two different programs,
otherwise, the DVR cannot be connected with the PC running
RAS or WebGuard.
When changing the port settings, you must change the port
settings on the PC running RAS or WebGuard as well. Refer to the
RAS Plus User Manual
Port Numbers Setup Screen
8200
8201
8016
10019
for details.
38 Document 900.0856
12/06