Table of Contents
Advertisement
Configuration
Press
functions:
•
•
•
•
•
•
•
•
You can control excessive event logging and remote notification of motions detected
after the motion dwell time by adjusting the motion ignoring dwell intervals. Highlight
the box beside Motion Ignoring Interval and press
1 to 10 seconds or Never appears. The DVR will not log and notify motion events
occurred during the preset interval range.
Highlighting the box beside Daytime Setup and pressing
Daytime range.
Rev 1.00
Note
You can set up motion zones one block at a time in groups of 9
or 16 individual block groups (9- and 16-channel DVR
respectively). A block group is positioned within the image area
using the Up and Down arrow buttons, and individual blocks
within the block groups are selected or cleared using the camera
buttons.
to display the menu screen. The menu on the setup screen has the following
Figure 3-63
Select — Activates highlighted blocks to detect motion.
Clear — Deactivates highlighted blocks so that they will not detect motion.
Reverse — Activates inactive highlighted blocks and deactivates active
highlighted blocks.
Select All — Activates all blocks to detect motion.
Clear All — Deactivates all blocks so that they will not detect motion.
Reverse All — Activates inactive blocks and deactivates active blocks.
OK — Accepts changes and closes Zone setup.
Cancel — Exits Zone setup without saving changes.
Note
The record action for motion events will not be affected by the
Motion Ignoring function.
Motion Detection Zone Menu
65
. A list of intervals ranging from
allow you to set up the
Document 900.0856
12/06
Advertisement
Table of Contents
