Figure 3-66 Motion Detection Actions 2 Screen - Honeywell HRXD9 User Manual

Configuration
Highlight the box under the Alarm-Out heading and press
appears. You can associate as many Alarm-Outs with that camera as you wish. When
the DVR detects motion on the selected camera's input, it triggers output signals on all
the associated Alarm-Out connectors. You can also have the DVR's internal buzzer
sound if motion is detected on the selected camera.
Highlight the box under the Notify heading and press
On and Off by highlighting Notification and pressing
items On and Off by highlighting that item and pressing
Highlight the desired box under the PTZ heading, and press
appear. Select the preset position for each PTZ camera, where you want PTZ cameras
to move to whenever the DVR detects motion on the selected camera's input.
Highlight the desired box under the Spot Monitor heading, and press
SPOT monitors and cameras appears. Each SPOT monitor can be associated with a
camera. The DVR will display the associated camera on the SPOT monitor whenever it
detects motions on the selected camera.
You can save your Motion Detection changes by highlighting Save and pressing
Selecting Cancel exits the screen without saving the changes.
Rev 1.00
Note For the Alarm-Out action, the alarm output and beep you select
should be set to the Event mode in the Alarm-Out setup screen
(Schedule tab).
to accept your changes.
Note For the Notify action, the notify item you select should be
enabled in the Notification setup screen and the DVR should be
registered in the RAS (Remote Administration System).
Figure 3-66 Motion Detection Actions 2 Screen
67
. A list of Alarm Outputs
. You can toggle the entire list
. You can toggle the individual
. Highlight OK and press
. A list of PTZ presets
. A list of
Document 900.0856
.
12/06