NETGEAR JR6150 User Manual page 137

2. Select ADVANCED > Advanced Setup > Remote Management.
3. Select the Turn Remote Management On check box.
4. Under Allow Remote Access By, specify the external IP addresses that the router's remote
management allows.
For enhanced security, restrict access to as few external IP addresses
Note:
as practical.
Select one of the following radio buttons:
• To allow access from a single IP address on the Internet, select the Only This
Computer radio button. Enter the IP address that is allowed access.
• To allow access from a range of IP addresses on the Internet, select the IP Address
Range radio button. To define the allowed range, enter a beginning and ending IP
address.
• To allow access from any IP address on the Internet, select the Everyone radio
button.
5. Specify the port number for accessing the router user interface.
Normal web browser access uses the standard HTTP service port 80. For greater
security, enter a custom port number for the remote router user interface. Choose a
number from 1024 through 65535, but do not use the number of any common service
port. The default is 8080, which is a common alternate for HTTP.
6. Click the Apply button.
When you access your router from the Internet, type your router's WAN IP address in your
browser's address or location field followed by a colon (:) and the custom port number. For
example, if your external address is 203.0.113.123 and you use port number 8080, enter
http://203.0.113.123:8080 in your browser.
A750 Wireless Dual Band Gigabit Router JR6150
Advanced Settings
137