NETGEAR AC750 JR6150 Installation Manual

Installation Guide
AC750 Wireless Dual Band Gigabit Router JR6150
Package Contents
AC750 Wireless Dual Band Gigabit Router
Power adapter Ethernet cable
Step 1.
Unplug the power
to turn off your modem.
DSL
or Cable
Internet
Modem
Step 4.
Connect the power adapter to the
router, then plug it into an outlet.
Wait until the Wireless LED turns
solid green.
If none of the LEDs light, make sure that the
Power On/Off button is in the on position
(pushed in).
Step 2.
Connect one end of the blue
Ethernet cable to your modem,
and the other end to the Internet
port on your router.
AC750 Wireless Dual
Power
Band Gigabit Router
On/Off
Step 5.
Connect the router
to your computer.
Use another Ethernet cable to establish
a wired connection as shown in this diagram.
(Optionally) Connect wirelessly by using the
preset wireless security settings located
on the bottom label.
Step 3.
Plug in, then turn on your modem.
Wait approximately 2 minutes
until your modem turns on.
If your modem has a battery backup,
first remove and reinsert the battery
before connecting your modem to power.
(not included)
Step 6.
Open a browser.
If the web page does not display,
close and reopen the browser and
enter http://www.routerlogin.net
in the address bar, or check the
"Troubleshooting" chapter of the
user manual.