Simplified Setup Mode; System Configuration Dialog; Appendix B Initializing The Sensor - Cisco IPS 7.1 Installation Manual

Simplified Setup Mode

Simplified Setup Mode
The sensor automatically calls the setup command when you connect to the sensor using a console cable
and the sensor basic network settings have not yet been configured. The sensor does not call automatic
setup under the following conditions:
•
•
•
When you enter the setup command, an interactive dialog called the System Configuration Dialog
appears on the system console screen. The System Configuration Dialog guides you through the
configuration process. The values shown in brackets next to each prompt are the default values last set.

System Configuration Dialog

When you enter the setup command, an interactive dialog called the System Configuration Dialog
appears on the system console screen. The System Configuration Dialog guides you through the
configuration process. The values shown in brackets next to each prompt are the current values.
You must go through the entire System Configuration Dialog until you come to the option that you want
to change. To accept default settings for items that you do not want to change, press Enter.
To return to the EXEC prompt without making changes and without going through the entire System
Configuration Dialog, press Ctrl-C. The System Configuration Dialog also provides help text for each
prompt. To access the help text, enter
When you complete your changes, the System Configuration Dialog shows you the configuration that
you created during the setup session. It also asks you if you want to use this configuration. If you enter
, the configuration is saved. If you enter
yes
again. There is no default for this prompt; you must enter either
You can configure daylight savings time either in recurring mode or date mode. If you choose recurring
mode, the start and end days are based on week, day, month, and time. If you choose date mode, the start
and end days are based on month, day, year, and time. Choosing disable turns off daylight savings time.
You only need to set the date and time in the System Configuration Dialog if the system is an appliance
Note
and is NOT using NTP.
The System Configuration Dialog is an interactive dialog. The default settings are displayed.
Note
Example B-1
Example B-1
At any point you may enter a question mark '?' for help.
User ctrl-c to abort configuration dialog at any prompt.
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.1
B-2
When initialization has already been successfully completed.
If you have recovered or downgraded the sensor.
If you have set the host configuration to default after successfully configuring the sensor using
automatic setup.
shows a sample System Configuration Dialog.
Example System Configuration Dialog
--- Basic Setup ---
--- System Configuration Dialog ---
at a prompt.
?
, the configuration is not saved and the process begins
no
Appendix B Initializing the Sensor
or .
yes no
OL-24002-01