Cisco IAD1101 Installation Manual

Preparing for Installation
This chapter describes the tasks you must perform before you begin to install the Cisco IAD1101
integrated access device and includes the following sections:
Safety
•
• Site Requirements
Required Tools and Equipment
•
Verifying Contents
•
Safety
Any device that uses electricity must be handled carefully; follow these guidelines to ensure general
safety:
• Keep the chassis area clear and dust-free during and after installation.
Keep tools away from walk areas where you and others could fall over them.
•
• Do not wear loose clothing that could get caught in the chassis. Fasten your tie or scarf and roll up
your sleeves.
• Wear safety glasses if you are working under any conditions that might be hazardous to your eyes.
Do not perform any action that creates a potential hazard to people or makes the equipment unsafe.
•
Ultimate disposal of this product should be handled according to all national laws and
Warning
regulations.
Maintaining Safety with Electricity
Before working on equipment that is connected to power lines, remove jewelry
Warning
(including rings, necklaces, and watches). Metal objects will heat up when connected
to power and ground and can cause serious burns or can weld the metal object to the
terminals.
78-10836-01
Cisco IAD1101 Integrated Access Device Hardware Installation Guide
C H A P T E R
2
2-1