Extending The Ips 4270-20 From The Rack - Cisco IPS 7.1 Installation Manual

Installing the Rail System Kit
Step 9 Install the electrical cables at the back of the IPS 4270-20.
For More Information
•
•

Extending the IPS 4270-20 from the Rack

You can extend the IPS 4270-20 from the rack for service or removal.
Caution You can only extend the IPS 4270-20 from the rack if the cable management arm is correctly installed
with the cables routed through it or if all cables are disconnected from the back of the chassis. Otherwise,
you risk damage to the cables and a possible shock hazard if the power cables get caught between the
chassis and the rack.
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.1
5-26
PC I-E x4
4
PC I-X 10
3 0 M H z
2
1
CO NS OL
E
PS2
UID
For the procedure for installing the cable management arm, see
Arm, page 5-28.
For information on installing connections to the IPS 4270-20, see
page 5-35.
P S 1
Re se rv
ed
fo r
Fu tu re
Us e
MG MT 0/0
PCI -E x4
9 PCI -E x8
8 PCI -E x4
7
PCI -E x8
6
5 PCI -E x4
4 PCI -X 100
3
MHz
2
1
PS1
Rese rved
CON SOL
E for
Futu re
Use
MGM T 0/0
1
Chapter 5 Installing the IPS 4270-20
Installing the Cable Management
Installing the IPS 4270-20,
OL-24002-01