Verifying The Status Of The Asa 5585-X Ips Ssp - Cisco IPS 7.1 Installation Manual

Verifying the Status of the ASA 5585-X IPS SSP

To connect to the SFP/SFP+ port if you are using fiber ports, follow these steps:
Install the SFP/SFP+ module.
Step 1
Connect one end of the LC cable to the SFP/SFP+.
Step 2
Connect the other end of the LC cable to a network device, such as a router or switch.
Step 3
For More Information
For a table listing the supported SFP/SFP+ modules, see
Verifying the Status of the ASA 5585-X IPS SSP
You can use the show module 1 command to verify that the ASA 5585-X IPS SSP is up and running.
The following values are valid for the Status field:
•
•
•
•
•
•
•
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.1
9-12
—The ASA 5585-X IPS SSP is being detected and the control communication is
Initializing
being initialized by the system.
—The ASA 5585-X IPS SSP has completed initialization by the system.
Up
—The system encountered an error communicating with the ASA 5585-X IPS SSP.
Unresponsive
—The ASA 5585-X IPS SSP is reloading.
Reloading
—The ASA 5585-X IPS SSP is shutting down.
Shutting Down
—The ASA 5585-X IPS SSP is shut down.
Down
—The ASA 5585-X IPS SSP is attempting to download a recovery image.
Recover
Chapter 9
9
8
7
6
S F P /S F
P +
9
8
7
6
S F P /S F
SFP/SFP+ Modules, page
Installing and Removing the ASA 5585-X IPS SSP
P +
9-9.
OL-24002-01