Installing Optional Pci Cards - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Installing the Accessories
Step 11
Step 12

Installing Optional PCI Cards

Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
5-16
Close the cover.
a. Close the right side of the cover.
Close the left side of the cover, and press firmly along the edge to lock in
b.
place.
Replace the screw at the front of the chassis.
c.
Connect the new system power cable to the power-supply 2 cable connector (PS2)
on the back panel of the appliance.
You can install the following optional PCI cards in the IDS-4235 and IDS-4250.
The optional PCI cards provide additional sensing interfaces.
SX card (1000BASE-SX sensing interface, part number,
•
IDS-4250-SX-INT=)
You can install the SX card in the upper PCI slot on the IDS-4250 series
appliances.
XL card (accelerated 1000BASE-SX interface with MTRJ, part number
•
IDS-XL-INT=)
You can install the XL card in the upper PCI slot in the IDS-4250 series
appliances. The XL card accelerates the performance of the IDS-4250 up to
1 Gbps. You can use an MTRJ cable (part number
CAB-MTRJ-SC-MM-3M=) to connect the fiber port on the XL card to the
switch on the network. You can order this cable when you order the XL card.
See Disconnecting the XL Card Fiber Ports, page
disconnecting the fiber ports the first time you boot the IDS-4250 after
upgrading with the XL card.
4FE card (four-port 10/100BASE-TX fast Ethernet sensing interface, part
•
number IDS-4FE-INT=)
You can install the 4FE card in the lower PCI slot in the IDS-4235 and
IDS-4250 series appliances.
Chapter 5 Installing the IDS-4235 and IDS-4250
5-19, for information about
78-15597-02