Surface Mounting - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Surface Mounting

Warning
Surface Mounting
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
3-6
Only trained and qualified personnel should be allowed to install, replace, or
service this equipment. Statement 1030
The IDS-4215 accessories kit contains the following:
• DB25 connector
DB9 connector
•
• Rubber mounting feet
Rack mounting kit—screws, washers, and metal bracket
•
RJ45 console cable
•
6-ft Ethernet cable
•
If you are not rack mounting the IDS-4215, you must attach the rubber feet to the
bottom of the IDS-4215 as shown in
shipped in the accessories kit.
Chapter 3
Figure 3-4 on page 3-7. The rubber feet are
Installing the IDS-4215
78-15597-02