Installing The Accessories - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Chapter 5 Installing the IDS-4235 and IDS-4250
Caution
Step 6
Step 7
Step 8

Installing the Accessories

Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
If your BIOS version is earlier than A04, you must apply the BIOS upgrade before
installing the version 4.x software on the IDS-4235 and IDS-4250. See
the BIOS, page 5-7.
Initialize your appliance.
See Initializing the Sensor, page
Upgrade your appliance to the most recent Cisco IDS software.
See Obtaining Cisco IDS Software, page
Assign the interfaces.
See Assigning and Enabling the Sensing Interface, page
You are now ready to configure intrusion detection on your appliance.
This section describes the contents of the IDS-4235 and the IDS-4250 accessories
package and how to install the accessories.
This section contains these topics:
Accessories Package Contents, page 5-12
•
• Installing and Removing the Bezel, page 5-12
Installing the Power Supply, page 5-13
•
• Installing Optional PCI Cards, page 5-16
Disconnecting the XL Card Fiber Ports, page 5-19
•
Removing and Replacing the SCSI Hard-Disk Drive, page 5-20
•
• Four-Post Rack Installation, page 5-23
Two-Post Rack Installation, page 5-34
•
10-2, for the procedure.
9-1, for the procedure.
Installing the Accessories
Upgrading
10-9, for the procedure.
5-11