Table of Contents
Advertisement
Chapter 5
Installing the IDS-4235 and IDS-4250
Installing the IDS-4235 and IDS-4250
Warning
Caution
Step 1
Step 2
Step 3
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
Only trained and qualified personnel should be allowed to install, replace, or
service this equipment. Statement 1030
Be sure to read the safety warnings in the Regulatory Compliance and Safety
Information for the Cisco Intrusion Detection System 4200 Series Appliance
Sensor and follow proper safety procedures when performing these steps.
To install the IDS-4235 and IDS-4250 on your network, follow these steps:
Position the appliance on the network.
See
Placing an Appliance on Your Network, page
places to position an appliance.
Attach the power cord to the appliance and plug it in to a power source (a UPS is
recommended).
Use the dual serial communication cable (PN 72-1847-01, included in the
accessory kit) to attach a laptop to the COM1 (serial) port of the appliance (see
Table 5-3
for a list of the terminal settings), or connect a keyboard and monitor to
the appliance.
Table 5-3
Terminal Settings
Terminal
Bits per second
Data bits
Parity
Stop bits
Flow control
Installing the IDS-4235 and IDS-4250
1-6, for information on the best
Setting
9600
8
None
1
Hardware or RTS/CTS
5-9
Advertisement
Table of Contents
Troubleshooting
