Table of Contents
Advertisement
IDSM-2 Configuration Tasks
Cisco IOS Software Commands
EXEC Commands
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
10-106
This section lists the Cisco IOS software commands that the IDSM-2 supports.
These commands are grouped according to mode.
For more detailed information on Cisco IOS software commands, refer to the
command references found on Cisco.com. See the Cisco Intrusion Detection
System (IDS) Hardware and Software Version 4.1 Documentation Guide that
shipped with your sensor for instructions on how to locate these documents.
This section contains the following topics:
EXEC Commands, page 10-106
•
Configuration Commands, page 10-108
•
The following commands are all performed in EXEC mode:
clock read-calendar
•
Updates the clock time to the calendar time.
•
clock set time date
Sets the current time and date.
•
clock update-calendar
Updates the calendar time to the clock time.
hw-module module slot_number reset
•
Resets the IDSM-2 into the partition specified by the boot device variable; if
the boot device variable has not been set, the IDSM-2 is reset to the
application partition by default. Use the command show boot device module
module_number to view the current setting of the boot device variable.
•
hw-module module slot_number reset cf:1
Resets the module into the maintenance partition.
•
hw-module module slot_number shutdown
Shuts down the module so that it can be safely removed from the chassis.
reload
•
Reloads the entire switch.
Chapter 10
Configuring the Sensor Using the CLI
78-15597-02
Advertisement
Table of Contents
Troubleshooting
