Table of Contents
Advertisement
Installing the Accessories
Remove the PCI slot cover.
Step 7
a.
b.
Insert the PCI card into the proper PCI slot of the riser card (according to which
Step 8
card you have), using enough pressure so that the card pops securely into place.
Be sure to support the riser card while inserting the PCI card, otherwise, you could
Caution
cause the riser card to flex and damage the riser card or main board.
The IDS-4250 supports only one of the following cards in a PCI slot: the SX card
Caution
(upper PCI slot), the XL card (upper PCI slot), or the 4FE card (lower PCI slot).
The IDS-4235 supports only the 4FE card in the lower PCI slot.
Step 9
Check the back of the chassis to be sure the card is flush with the PCI slot, and
then return the PCI slot release to its original position to lock the PCI slot card in
place.
Close the cover.
Step 10
a.
b.
c.
Replace the power and network connections.
Step 11
Note
Reboot the appliance.
Step 12
Make sure the fiber ports are not connected the first time you boot the appliance
Caution
after you have installed the XL card. For more information, see
XL Card Fiber Ports, page
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
5-18
Pull the slot release pin at the back of the chassis to unlock the PCI slot covers
and pull the slot release toward you.
Remove the PCI slot cover.
Close the right side of the cover.
Close the left side of the cover, and press firmly along the edge to lock in
place.
Replace the screw at the front of the chassis.
The monitoring interface connector is now on the XL card.
Chapter 5
5-19.
Installing the IDS-4235 and IDS-4250
Disconnecting the
78-15597-02
Advertisement
Table of Contents
Troubleshooting
