Setting Up The Spa932 Attendant Console - Cisco SPA942 - - IP Phone Administration Manual

Configuring the SPA932 Attendant Console

Setting Up the SPA932 Attendant Console

Setting Up the SPA932 Attendant Console
STEP 1
STEP 2
STEP 3
Cisco SPA and Wireless IP Phone Administration Guide
To configure the server to use the SPA932, configure each extension that will be
monitored by the attendant console. The SPA932 is a SIP subscriber in relation to
each SIP proxy server, which allows the SPA932 to receive NOTIFY messages
from the SIP proxy that indicate the status of each monitored phone. In general, the
SIP proxy is identified by its IP address, or through a hostname if DNS is
configured. The way in which each phone and extension is identified is vendor-
specific.
To set up the SPA932 attendant console:
Complete the physical installation of the SPA932 unit, which connects it to the
phone. For instructions on installing the SPA932 and an introduction to its use, refer
to the 32 Button Attendant Console for the SPA962 IP Phone Quick Installation
Cisco Small Business Pro SPA525G User Guide (SIP),
Guide or the
Cisco.com.
Configure one of the following SIP proxy servers:
• SPA9000—See
(verify that your version of the SPA9000 supports the SPA932).
• BroadSoft—See
page 176.
• Asterisk—See
page 177.
Configure the SPA932 using the web UI. The web server must be connected to the
phone to which the SPA932 is physically attached.
Configuring the SPA9000 for the SPA932, page 176
Configuring the BroadSoft Server for the SPA932,
Configuring the Asterisk Server for the SPA932,
NOTE: The SPA962 phone must be running
Release 5. 1 . 1 2 or later. (All releases for the
SPA525G are supported.) Also, CTI must be
enabled on the phone for an attached SPA932
to properly monitor the IP phone's line status
when the SIP proxy server type is set to
SPA9000. See the
on page 89.
"Configuring SIP" section
9
available on
175