Mounting The Access Point Below A Suspended Ceiling - Cisco 1130AG - Aironet - Wireless Access Point Hardware Installation Manual

Chapter 2 Installing the Access Point
Drill a 3/16 in. (4.7 mm) hole at the X mounting hole locations you marked.
Step 2
Insert the wall anchors into the mounting holes.
Step 3
If needed, drill or cut a cable access hole (see
Step 4
power cables and pull the cables through the access hole until you have about 1 foot of exposed cables
protruding from the hole.
Note
Position the mounting plate over the wall anchors or the drilled holes.
Step 5
Step 6 Insert the appropriate pan head screws in the X mounting holes and tighten.
To attach the access point to the mounting plate, see
section on page

Mounting the Access Point Below a Suspended Ceiling

You should review
Figure 2-7
CEILING
GRID
WIDTH
1
2
OL-8369-05
You can optionally insert the Ethernet cable and the power cable (if used) through the cable
access notch in access point housing (see
2-16.
Figure 2-7 before beginning the mounting process.
Adjustable T-Rail Clips
1
2
3
38 24 15
MM
INCH
1-1/2 15/16 9/16
A B C
2
1
T-rail locking screws
Mounting plate screw holes

Mounting the Access Point Below a Suspended Ceiling

Figure 2-6) large enough for the Ethernet and possibly the
Figure 2-5).
"Attaching the Access Point to the Mounting Plate"
2
C B A
9/16 15/16 1-1/2
INCH
MM
15 24 38
3
2
3
T-rail width detents (A, B, or C)
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
WIDTH
GRID
CEILING
2-13